Rx7 FD - Step-by-Step (30min-1hr)
Step 1
Step 1
Step 1
Headlights Up , use the Philips #2 screwdriver to remove the black plastic bezel screws.
Step 2
Step 1
Step 1
Don't forget the other side.
for a total of 4 screws per headlight.
Step 3
Step 1
Right after removing the front bezel , the headlights lid screws become accessible , using the same screwdriver , remove the front 2 lid screws
Step 4
After the previous step , bring the headlight down and remove the 2 screws in the back holding the lid,
remove the lid by pulling up toward the sky.
Step 4
Using the plier remove the 3 Black adjusting clips holding the OEM headlights
Step 5
Disconnect the OEM headlights and install Rx-Lights' Headlights
***Step 6***
Install the LED drivers like pictured, on the opposite side of the stopper arm.
***failure to do so may pinch a wire or damage the pop-up motors.***
optional ( Halos & Demons)
the connector for from the pnp harness can be install behind the headlight
1. LED DRIVER
2.PNP CONNECTORS
***Step 7***
Before re-installing the bezels and lids
close the headlights by hand by turning the red knob (under the plastic boot) (by the fender liners)
Step 8
Once manual clearance is complete , re-install the front bezel and headlights lids
Step 9
Bring the screw driver with you when going for a ride & adjust the projector cut-off line through the front bezel.
(usually 3 or 4 times for perfection)
Step 10
Step 10
Drive Safe :)